Sleep (system call)

A computer program (process, task, or thread) may sleep, which places it into an inactive state for a period of time. Eventually the expiration of an interval timer, or the receipt of a signal or interrupt causes the program to resume execution.

Usage

A typical sleep system call takes a time value as a parameter, specifying the minimum amount of time that the process is to sleep before resuming execution. The parameter typically specifies seconds, although some operating systems provide finer resolution, such as milliseconds or microseconds.

Windows

On Windows, the Sleep() function takes a single parameter of the number of milliseconds to sleep. [1] The Sleep() function is included in kernel32.dll, but no sleep command (executable) is natively available for scripts (batch files). It can be found in collections of Windows utilities like Windows 2003 Resource Kit. [2]

Unix

On Unix-like operating systems, the sleep() function is called providing a single parameter of type unsigned integer of the number of seconds to sleep. [3] (For more precise sleep times one can use the usleep() function.) [4]

C examples

In Windows OS:

Sleep(2*1000);  // Sleep for 2 seconds

In Unix:

sleep(2);       // Sleep for 2 seconds

Low level functionality

Sleep causes the thread or process to give up the remainder of its time slice and stay in the Not Runnable state for the specified duration. While there is generally a guarantee for the minimum time period, there is no strict guarantee that the thread will run immediately or soon, or even at all, once the specified time has passed. It is up to the scheduler's discretion, and dependent on thread priorities and implementation details such as timer resolutions when the sleeping thread will run again. On POSIX systems, the nanosleep and related syscalls are interruptible by signals, returning the remaining sleep time. The sleep library function, on the other hand, is implemented via the alarm syscall on many older systems, thus it only works by delivering a signal. The Windows Sleep function is non-interruptible due to absence of signals (other than the thread or its process being terminated), although the related SleepEx function can be used to put the thread into an alertable state, allowing APC calls being made while the thread is sleeping. Also, a thread can technically be "interrupted" in case e.g. the process terminates due to an exception in a different thread.

Uses

Some system programs that never terminate execute an event loop, going to sleep at the start of each cycle and waiting for some event to awaken them. Once an event is received, the program services the event, then returns to the beginning of the next wait cycle.

Other programs periodically poll for events by going to sleep and resuming execution after a specific interval of time. Once execution is resumed, the program polls for events or status changes, and then services any that occurred while it was asleep. After servicing the events, the program then goes to sleep again for the next time interval. Certain kinds of heartbeat events or keep-alive signals can be generated by these kinds of programs.

Uninterruptible sleep

An uninterruptible sleep state is a sleep state that won't handle a signal right away. It will wake only as a result of a waited-upon resource becoming available or after a time-out occurs during that wait (if specified when put to sleep). It is mostly used by device drivers waiting for disk or network IO (input/output). When the process is sleeping uninterruptibly, signals accumulated during the sleep will be noticed when the process returns from the system call or trap.

In Unix-like systems the command 'ps -l' uses code "D" for the uninterruptible sleep state of a process.

See also

References

This article is issued from Wikipedia - version of the 4/9/2014. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.