# Trajectory of a projectile

Trajectories of a projectile with air drag and varying initial velocities

In physics, the ballistic trajectory of a projectile is the path that a thrown or launched projectile or missile without propulsion will take under the action of gravity, neglecting all other forces, such as friction from aerodynamic drag.

The United States Department of Defense and NATO define a ballistic trajectory as a trajectory traced after the propulsive force is terminated and the body is acted upon only by gravity and aerodynamic drag.[1] A special case of a ballistic trajectory for a rocket is a lofted trajectory, a trajectory with an apogee greater than the minimum-energy trajectory to the same range. In other words, the rocket travels higher and by doing so it uses more energy to get to the same landing point. This may be done for various reasons such as increasing distance to the horizon to give greater viewing/communication range or for changing the angle with which a missile will impact on landing. Lofted trajectories are sometimes used in both missile rocketry and in spaceflight.[2]

The following applies for ranges which are small compared to the size of the Earth. For longer ranges see sub-orbital spaceflight.

## Notation

In the equations on this page, the following variables will be used:

• g: the gravitational accelerationusually taken to be 9.81 m/s2 near the Earth's surface
• θ: the angle at which the projectile is launched
• v: the speed at which the projectile is launched
• y0: the initial height of the projectile
• d: the total horizontal distance traveled by the projectile

Ballistics (gr. βάλλειν ('ba'llein'), "to throw") is the science of mechanics that deals with the flight, behavior, and effects of projectiles, especially bullets, gravity bombs, rockets, or the like; the science or art of designing and accelerating projectiles so as to achieve a desired performance. A ballistic body is a body which is free to move, behave, and be modified in appearance, contour, or texture by ambient conditions, substances, or forces, as by the pressure of gases in a gun, by rifling in a barrel, by gravity, by temperature, or by air particles. A ballistic missile is a missile only guided during the relatively brief initial powered phase of flight, whose course is subsequently governed by the laws of classical mechanics.

These formulae ignore aerodynamic drag and also assume that the landing area is at uniform height 0.

## Conditions at the final position of the projectile

### Distance traveled

Trajectories of projectiles launched at different elevation angles but the same speed of 10 m/s in a vacuum and uniform downward gravity field of 10 m/s2. Points are at 0.05 s intervals and length of their tails is linearly proportional to their speed. t = time from launch, T = time of flight, R = range and H = highest point of trajectory (indicated with arrows).

The total horizontal distance (d) traveled.

When the surface the object is launched from and is flying over is flat (the initial height is zero), the distance traveled is:

Thus the maximum distance is obtained if θ is 45 degrees. This distance is:

For explicit derivations of these results, see Range of a projectile.

### Time of flight

The time of flight (t) is the time it takes for the projectile to finish its trajectory.

As above, this expression can be reduced to

if θ is 45° and y0 is 0.

The above results are found in Range of a projectile.

### Angle of reach

The "angle of reach" is the angle (θ) at which a projectile must be launched in order to go a distance d, given the initial velocity v.

## Conditions at an arbitrary distance x

### Height at x

The height y of the projectile at distance x is given by

.

The third term is the deviation from traveling in a straight line.

### Velocity at x

The magnitude, of the velocity of the projectile at distance x is given by

.

#### Derivation

The magnitude |v| of the velocity is given by

,

where Vx and Vy are the instantaneous velocities in the x- and y-directions, respectively.

Here the x-velocity remains constant; it is always equal to v cos θ.

The y-velocity can be found using the formula

by setting vi = v sin θ, a = -g, and . (The latter is found by taking x = (v cos θ) t and solving for t.) Then,

and

.

The formula above is found by simplifying.

## Angle required to hit coordinate (x,y)

Vacuum trajectory of a projectile for different launch angles. Launch speed is the same for all angles, 50 m/s if "g" is 10 m/s2.

To hit a target at range x and altitude y when fired from (0,0) and with initial speed v the required angle(s) of launch are:

The two roots of the equation correspond to the two possible launch angles, so long as they aren't imaginary, in which case the initial speed is not great enough to reach the point (x,y) selected. This formula allows one to find the angle of launch needed without the restriction of y = 0.

Derivation

First, two elementary formulae are called upon relating to projectile motion:

(1)
(2)

Solving (1) for t and substituting this expression in (2) gives:

(Trigonometric identity)

Let

Instead of a coordinate (x,y) it is required to hit a target at distance r and angle of elevation (polar coordinates), use the relationships and and substitute to get:

## Catching balls

If a projectile, such as a baseball or cricket ball, travels in a parabolic path, with negligible air resistance, and if a player is positioned so as to catch it as it descends, he sees its angle of elevation increasing continuously throughout its flight. The tangent of the angle of elevation is proportional to the time since the ball was sent into the air, usually by being struck with a bat. Even when the ball is really descending, near the end of its flight, its angle of elevation seen by the player continues to increase. The player therefore sees it in line with a point ascending vertically from the batsman at constant speed. Finding the place from which the ball appears to rise steadily helps the player to position himself correctly to make the catch. If he is too close to the batsman who has hit the ball, it will appear to rise at an accelerating rate. If he is too far from the batsman, it will appear to slow rapidly, and then to descend.

Proof

Suppose the ball starts with a vertical component of velocity of upward, and a horizontal component of velocity of toward the player who wants to catch it. Its altitude above the ground is given by:

where is the time since the ball was hit.

The total time for the flight, until the ball is back down to the ground, , is given by:

The horizontal component of the distance the ball travels from its starting point to time is

The total horizontal distance the ball travels from its starting point to the point where it is caught is:

The horizontal component of the ball's distance from the catcher at time is:

The tangent of the angle of elevation of the ball, as seen by the catcher, is:

While the ball is in flight:

The bracket in this last expression is constant for a given flight. Therefore, the tangent of the angle of elevation of the ball, as seen by the player who is properly positioned to catch it, is directly proportional to the time since the ball was hit.

## Trajectory of a projectile with air resistance

Trajectories of a mass thrown at an angle of 70°:
without drag
with Stokes drag
with Newton drag

Air resistance will be taken to be in direct proportion to the velocity of the particle (i.e. ). This is valid at low speed (low Reynolds number), and this is done so that the equations describing the particle's motion are easily solved. At higher speed (high Reynolds number) the force of air resistance is proportional to the square of the particle's velocity (see drag equation). Here, , and will be used to denote the initial velocity, the velocity along the direction of x and the velocity along the direction of y, respectively. The mass of the projectile will be denoted by m. For the derivation only the case where is considered. Again, the projectile is fired from the origin (0,0).

The assumption that air resistance may be taken to be in direct proportion to the velocity of the particle is not correct for a typical projectile in air with a velocity above a few tens of meters/second, and so this equation should not be applied to that situation.

Free body diagram of a body on which only gravity and air resistance acts

The free body diagram on the right is for a projectile that experiences air resistance and the effects of gravity. Here, air resistance is assumed to be in the direction opposite of the projectile's velocity. (actually is more realistic, but not used here, to ensure an analytic solution,) is written due to the initial assumption of direct proportionality implies that the air resistance and the velocity differ only by a constant arbitrary factor with units of N*s/m.

As an example, say that when the velocity of the projectile is 4 m/s, the air resistance is 7 newtons (N). When the velocity is doubled to 8 m/s, the air resistance doubles to 14 N accordingly. In this case, k = 7/4 Ns/m. Note that k is needed in order to relate the air resistance and the velocity by an equal sign: otherwise, it would be stating incorrectly that the two are always equal in value (i.e. 1 m/s of velocity gives 1 N of force, 2 m/s gives 2 N etc.) which isn't always the case, and also it keeps the equation dimensionally correct (a force and a velocity cannot be equal to each other, e.g. m/s = N). As another quick example, Hooke's Law () describes the force produced by a spring when stretched a distance x from its resting position, and is another example of a direct proportion: k in this case has units N/m (in metric).

To show why k = 7/4 Ns/m above, first equate 4 m/s and 7 N:

(Incorrect)

(Introduction of k)

( cancels)

For more on proportionality, see: Proportionality (mathematics)

The relationships that represent the motion of the particle are derived by Newton's Second Law, both in the x and y directions. In the x direction and in the y direction .

This implies that:

(1), and

(2)
Solving (1) is an elementary differential equation, thus the steps leading to a unique solution for and, subsequently, will not be enumerated. Given the initial conditions (where is understood to be the x component of the initial velocity) and for :

(1a)

(1b)

While (1) is solved much in the same way, (2) is of distinct interest because of its non-homogeneous nature. Hence, we will be extensively solving (2). Note that in this case the initial conditions are used and when .

(2)

(2a)

This first order, linear, non-homogeneous differential equation may be solved a number of ways; however, in this instance, it will be quicker to approach the solution via an integrating factor: .

(2c)

(2d)

(2e)

(2f)

(2g)

And by integration we find:

(3)

Solving for our initial conditions:

(2h)

(3a)

With a bit of algebra to simplify (3a):
(3b)

An example is given using values for the mass and terminal velocity for a baseball taken from .

m = 0.145 kg (5.1 oz)
v0 = 44.7 m/s (100 mph)
g = -9.81 m/s² (-32.2 ft/s²)
vt = -33.0 m/s (-73.8 mph)
.

The more realistic trajectory can not be calculated analytically, but only by numerical simulations.

Similarly to above:

However, this takes advantage of the fact that horizontally, acceleration is always negative. As acceleration is negative while velocity is positive and positive while velocity is negative, a projectile fired upwards requires the absolute value to be taken of the vertical velocity, which makes an analytical solution for vertical position more complex.

Where is gravitational acceleration set to some constant, such as standard gravity:

for constant gravity

or, even more complex,

for gravity as a function of height above a planet's surface, where

• is the planet's gravity at the surface.
• r is the planet's radius.