Tin(II) chloride

Tin(II) chloride
Names
IUPAC names
Tin(II) chloride
Tin dichloride
Other names
Stannous chloride
Tin salt
Tin protochloride
Identifiers
7772-99-8 YesY
10025-69-1 (dihydrate) N
3D model (Jmol) Interactive image
ChEBI CHEBI:78067 N
ChemSpider 22887 N
ECHA InfoCard 100.133.348
E number E512 (acidity regulators, ...)
PubChem 24479
RTECS number XP8700000 (anhydrous)
XP8850000 (dihydrate)
UN number 3260
Properties
SnCl2
Molar mass 189.60 g/mol (anhydrous)
225.63 g/mol (dihydrate)
Appearance White crystalline solid
Odor odorless
Density 3.95 g/cm3 (anhydrous)
2.71 g/cm3 (dihydrate)
Melting point 247 °C (477 °F; 520 K) (anhydrous)
37.7 °C (dihydrate)
Boiling point 623 °C (1,153 °F; 896 K) (decomposes)
83.9 g/100 ml (0 °C)
Hydrolyses in hot water
Solubility soluble in ethanol, acetone, ether, Tetrahydrofuran
insoluble in xylene
Structure
Layer structure
(chains of SnCl3 groups)
Trigonal pyramidal (anhydrous)
Dihydrate also three-coordinate
Bent (gas phase)
Hazards
Main hazards Irritant, dangerous for aquatic organisms
Safety data sheet See: data page
ICSC 0955 (anhydrous)
ICSC 0783 (dihydrate)
NFPA 704
Flammability code 0: Will not burn. E.g., water Health code 1: Exposure would cause irritation but only minor residual injury. E.g., turpentine Reactivity code 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g., liquid nitrogen Special hazards (white): no codeNFPA 704 four-colored diamond
0
1
0
Lethal dose or concentration (LD, LC):
700 mg/kg (rat, oral)
10,000 mg/kg (rabbit, oral)
250 mg/kg (mouse, oral)[1]
Related compounds
Other anions
Tin(II) fluoride
Tin(II) bromide
Tin(II) iodide
Other cations
Germanium dichloride
Tin(IV) chloride
Lead(II) chloride
Supplementary data page
Refractive index (n),
Dielectric constantr), etc.
Thermodynamic
data
Phase behaviour
solidliquidgas
UV, IR, NMR, MS
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
N verify (what is YesYN ?)
Infobox references

Tin(II) chloride, also known as stannous chloride, is a white crystalline solid with the formula SnCl2. It forms a stable dihydrate, but aqueous solutions tend to undergo hydrolysis, particularly if hot. SnCl2 is widely used as a reducing agent (in acid solution), and in electrolytic baths for tin-plating. Tin(II) chloride should not be confused with the other chloride of tin; tin(IV) chloride or stannic chloride (SnCl4).

Chemical structure

SnCl2 has a lone pair of electrons, such that the molecule in the gas phase is bent. In the solid state, crystalline SnCl2 forms chains linked via chloride bridges as shown. The dihydrate is also three-coordinate, with one water coordinated on to the tin, and a second water coordinated to the first. The main part of the molecule stacks into double layers in the crystal lattice, with the "second" water sandwiched between the layers.

Structures of tin(II) chloride and related compounds
Ball-and-stick models of the crystal structure of SnCl2[2]

Chemical properties

Tin(II) chloride can dissolve in less than its own mass of water without apparent decomposition, but as the solution is diluted hydrolysis occurs to form an insoluble basic salt:

SnCl2 (aq) + H2O (l) Sn(OH)Cl (s) + HCl (aq)

Therefore, if clear solutions of tin(II) chloride are to be used, it must be dissolved in hydrochloric acid (typically of the same or greater molarity as the stannous chloride) to maintain the equilibrium towards the left-hand side (using Le Chatelier's principle). Solutions of SnCl2 are also unstable towards oxidation by the air:

6 SnCl2 (aq) + O2 (g) + 2 H2O (l) → 2 SnCl4 (aq) + 4 Sn(OH)Cl (s)

This can be prevented by storing the solution over lumps of tin metal.[3]

There are many such cases where tin(II) chloride acts as a reducing agent, reducing silver and gold salts to the metal, and iron(III) salts to iron(II), for example:

SnCl2 (aq) + 2 FeCl3 (aq) → SnCl4 (aq) + 2 FeCl2 (aq)

It also reduces copper(II) to copper(I).

Solutions of tin(II) chloride can also serve simply as a source of Sn2+ ions, which can form other tin(II) compounds via precipitation reactions. For example, reaction with sodium sulfide produces the brown/black tin(II) sulfide:

SnCl2 (aq) + Na2S (aq) → SnS (s) + 2 NaCl (aq)

If alkali is added to a solution of SnCl2, a white precipitate of hydrated tin(II) oxide forms initially; this then dissolves in excess base to form a stannite salt such as sodium stannite:

SnCl2(aq) + 2 NaOH (aq) → SnO·H2O (s) + 2 NaCl (aq)
SnO·H2O (s) + NaOH (aq) → NaSn(OH)3 (aq)

Anhydrous SnCl2 can be used to make a variety of interesting tin(II) compounds in non-aqueous solvents. For example, the lithium salt of 4-methyl-2,6-di-tert-butylphenol reacts with SnCl2 in THF to give the yellow linear two-coordinate compound Sn(OAr)2 (Ar = aryl).[4]

Tin(II) chloride also behaves as a Lewis acid, forming complexes with ligands such as chloride ion, for example:

SnCl2 (aq) + CsCl (aq) → CsSnCl3 (aq)

Most of these complexes are pyramidal, and since complexes such as SnCl3 have a full octet, there is little tendency to add more than one ligand. The lone pair of electrons in such complexes is available for bonding, however, and therefore the complex itself can act as a Lewis base or ligand. This seen in the ferrocene-related product of the following reaction :

SnCl2 + Fe(η5-C5H5)(CO)2HgCl → Fe(η5-C5H5)(CO)2SnCl3 + Hg

SnCl2 can be used to make a variety of such compounds containing metal-metal bonds. For example, the reaction with dicobalt octacarbonyl:

SnCl2 + Co2(CO)8 → (CO)4Co-(SnCl2)-Co(CO)4

Preparation

Anhydrous SnCl2 is prepared by the action of dry hydrogen chloride gas on tin metal. The dihydrate is made by a similar reaction, using hydrochloric acid:

Sn (s) + 2 HCl (aq) → SnCl2 (aq) + H
2
(g)

The water then carefully evaporated from the acidic solution to produce crystals of SnCl2·2H2O. This dihydrate can be dehydrated to anhydrous using acetic anhydride.[5]

Uses

A solution of tin(II) chloride containing a little hydrochloric acid is used for the tin-plating of steel, in order to make tin cans. An electric potential is applied, and tin metal is formed at the cathode via electrolysis.

Tin(II) chloride is used as a mordant in textile dyeing because it gives brighter colours with some dyes e.g. cochineal. This mordant has also been used alone to increase the weight of silk.

It is used as a catalyst in the production of the plastic polylactic acid (PLA).

It also finds a use as a catalyst between acetone and hydrogen peroxide to form the tetrameric form of acetone peroxide.

Tin(II) chloride also finds wide use as a reducing agent. This is seen in its use for silvering mirrors, where silver metal is deposited on the glass:

Sn2+ (aq) + 2 Ag+ → Sn4+ (aq) + 2 Ag (s)

A related reduction was traditionally used as an analytical test for Hg2+(aq). For example, if SnCl2 is added dropwise into a solution of mercury(II) chloride, a white precipitate of mercury(I) chloride is first formed; as more SnCl2 is added this turns black as metallic mercury is formed. Stannous chloride can be used to test for the presence of gold compounds. SnCl2 turns bright purple in the presence of gold (see Purple of Cassius).

When mercury is analyzed using atomic absorption spectroscopy, a cold vapor method must be used, and tin (II) chloride is typically used as the reductant.

In organic chemistry, SnCl2 is mainly used in the Stephen reduction, whereby a nitrile is reduced (via an imidoyl chloride salt) to an imine which is easily hydrolysed to an aldehyde.[6]

The reaction usually works best with aromatic nitriles Aryl-CN. A related reaction (called the Sonn-Müller method) starts with an amide, which is treated with PCl5 to form the imidoyl chloride salt.

The Stephen reduction is less used today, because it has been mostly superseded by diisobutylaluminium hydride reduction.

Additionally, SnCl2 is used to selectively reduce aromatic nitro groups to anilines.[7]

SnCl2 also reduces quinones to hydroquinones.

Stannous chloride is also added as a food additive with E number E512 to some canned and bottled foods, where it serves as a color-retention agent and antioxidant.

SnCl2 is used in Radionuclide angiography to reduce the radioactive agent technetium-99m-pertechnetate to assist in binding to blood cells.

Aqueous Stannous Chloride is used by many precious metals refining hobbyists as an indicator of Gold and Platinum group metals in solutions.[8]

Molten SnCl2 can be oxidised to form highly crystalline SnO2 nanostructures.[9][10]

Notes

  1. "Tin (inorganic compounds, as Sn)". Immediately Dangerous to Life and Health. National Institute for Occupational Safety and Health (NIOSH).
  2. J. M. Leger; J. Haines; A. Atouf (1996). "The high pressure behaviour of the cotunnite and post-cotunnite phases of PbCl2 and SnCl2". J. Phys. Chem. Solids. 57 (1): 7–16. Bibcode:1996JPCS...57....7L. doi:10.1016/0022-3697(95)00060-7.
  3. H. Nechamkin (1968). The Chemistry of the Elements. New York: McGraw-Hill.
  4. B. Cetinkaya, I. Gumrukcu, M. F. Lappert, J. L. Atwood, R. D. Rogers and M. J. Zaworotko (1980). "Bivalent germanium, tin, and lead 2,6-di-tert-butylphenoxides and the crystal and molecular structures of M(OC6H2Me-4-But2-2,6)2 (M = Ge or Sn)". J. Am. Chem. Soc. 102 (6): 2088–2089. doi:10.1021/ja00526a054.
  5. W. L. F. Armarego; C. L. L. Chai (2009). Purification of laboratory chemicals (6 ed.). The United States of America: Butterworth-Heinemann.
  6. Williams, J. W. (1955). "β-Naphthaldehyde". Org. Synth.; Coll. Vol., 3, p. 626
  7. F. D. Bellamy & K. Ou (1984). "Selective reduction of aromatic nitro compounds with stannous chloride in non acidic and non aqueous medium". Tetrahedron Letters. 25 (8): 839–842. doi:10.1016/S0040-4039(01)80041-1.
  8. http://www.goldrefiningforum.com/phpBB3/
  9. A.R.Kamali, Thermokinetic characterisation of tin(11) chloride, J Therm Anal Calorim 118(2014) 99-104.
  10. A.R.Kamali et al.Transformation of molten SnCl2 to SnO2 nano-single crystals, Ceram Intern 40 (2014)8533-8538.

References

This article is issued from Wikipedia - version of the 6/6/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.