Pothead

This article is about a type of high-voltage electrical terminal. For a person who regularly uses Cannabis ("pot"), see Cannabis smoking.
A three phase electric circuit terminated with a pothead
Crossarms with two three phase electric circuits terminated with potheads

A pothead is a type of insulated electrical terminal used for transitioning between overhead line and underground high voltage cable or for connecting overhead wiring to equipment like transformers.[1] Its name comes from the process of potting or encapsulation of the conductors inside the terminal's insulating bushing.

Description

Potheads are used where higher voltage power lines go underground, generally voltages of 600 volts or greater. They are used mostly for service drops for commercial and industrial buildings. For lower voltages such as those used for residential service drops, another weather seal called a weatherhead is used.

The device consists of a molded plastic housing that attaches to the end of an electrical conduit that carries the underground cables up the utility pole to the crossarm. Multiple bushing insulators project from the plastic body, each ending at an electrical terminal. Each overhead wire is connected to a bushing terminal from which the current passes through a rod down the center of the bushing to the interior of the housing, where it is connected to a wire from the conduit. Thus the device allows the overhead conductors to pass into the conduit while serving as a seal to keep out water. The purpose of the bushings, which have corrugations moulded into their surfaces, is to provide enough creepage distance along their surface to prevent leakage current from the high voltage terminal from flowing to the grounded metal conduit.

Superseded

Pothead was once defined in Institute of Electrical and Electronics Engineers (IEEE) Std 48-1962 "Standards for Potheads." This standard was superseded by IEEE Std 48-1975 "IEEE Standard Test Procedures and Requirements for High-Voltage Alternating-Current Cable Terminations," and "pothead" was dropped from usage. The current standard is IEEE Std 48-2009.[2]

What was once called a pothead is now called a "Class I High-Voltage Cable Termination," which must meet these requirements:

  1. Electrical stress control
  2. Insulation between the conductors and ground
  3. An environmental seal

Alternatives

High voltage terminations conforming to IEEE Std 48-1990 and not requiring potting compound are illustrated below:

Transition of a 60kv powerline between overhead and underground 
Transition of a 4160 Volt powerline from overhead to underground 
Pothead for one phase 

See also

References

  1. ↑ Herman, Stephen L. (2011). Electrical Wiring: Industrial (14th ed.). Cengage Learning. p. 21. ISBN 1-111-12489-2.
  2. ↑ http://standards.ieee.org/findstds/standard/48-2009.html


This article is issued from Wikipedia - version of the 10/12/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.