A point source is a single identifiable localised source of something. A point source has negligible extent, distinguishing it from other source geometries. Sources are called point sources because in mathematical modeling, these sources can usually be approximated as a mathematical point to simplify analysis.
The actual source need not be physically small, if its size is negligible relative to other length scales in the problem. For example, in astronomy, stars are routinely treated as point sources, even though they are in actuality much larger than the Earth.
In three dimensions, the density of something leaving a point source decreases in proportion to the inverse square of the distance from the source, if the distribution is isotropic, and there is no absorption or other loss.
In mathematics, a point source is a singularity from which flux or flow is emanating. Although singularities such as this do not exist in the observable universe, mathematical point sources are often used as approximations to reality in physics and other fields.
Generally a source of light can be considered a point source if the resolution of the imaging instrument is too low to resolve its apparent size. There are two types and sources of light. A point source, and a extended source.
Mathematically an object may be considered a point source if its angular size, , is much smaller than the resolving power of the telescope:
where is the wavelength of light and is the telescope diameter.
- Light from a distant star seen through a small telescope
- Light passing through a pinhole or other small aperture, viewed from a distance much greater than the size of the hole
- Light from a street light in a large-scale study of light pollution or street illumination
Radio wave sources which are smaller than one radio wavelength are also generally treated as point sources. Radio emissions generated by a fixed electrical circuit are usually polarized, producing anisotropic radiation. If the propagating medium is lossless, however, the radiant power in the radio waves at a given distance will still vary as the inverse square of the distance if the angle remains constant to the source polarization.
Gamma ray and X-ray sources may be treated as a point source if sufficiently small. Radiological contamination and nuclear sources are often point sources. This has significance in health physics and radiation protection.
- Radio antennas are often smaller than one wavelength, even though they are many metres across
- Pulsars are treated as point sources when observed using radio telescopes
- In nuclear physics, a "hot spot" is a point source of radiation
Sound is an oscillating pressure wave. As the pressure oscillates up and down, an audio point source acts in turn as a fluid point source and then a fluid point sink. (Such an object does not exist physically, but is often a good simplified model for calculations.)
- Seismic vibration from a localised seismic experiment searching for oil
- Noise pollution from a jet engine in a large-scale study of noise pollution
- A loudspeaker may be considered as a point source in a study of the acoustics of airport announcements
Point sources are used as a means of calibrating ionizing radiation instruments. They are usually a sealed capsule and are most commonly used for gamma, x-ray and beta measuring instruments.
In vacuum, heat escapes as radiation isotropically. If the source remains stationary in a compressible fluid such as air, flow patterns can form around the source due to convection, leading to an anisotropic pattern of heat loss. The most common form of anisotropy is the formation of a thermal plume above the heat source. Examples:
- Geological hotspots on the surface of the Earth which lie at the tops of thermal plumes rising from deep inside the Earth
- Plumes of heat studied in thermal pollution tracking.
Fluid point sources are commonly used in fluid dynamics and aerodynamics. A point source of fluid is the inverse of a fluid point sink (a point where fluid is removed). Whereas fluid sinks exhibit complex rapidly changing behaviour such as is seen in vortices (for example water running into a plug-hole or tornadoes generated at points where air is rising), fluid sources generally produce simple flow patterns, with stationary isotropic point sources generating an expanding sphere of new fluid. If the fluid is moving (such as wind in air or currents in water) a plume is generated from the point source.
- Air pollution from a power plant flue gas stack in a large scale analysis of air pollution
- Water pollution from an oil refinery wastewater discharge outlet in a large scale analysis of water pollution
- Gas escaping from a pressurised pipe in a laboratory
- Smoke is often released from point sources in a wind tunnel in order to create a plume of smoke which highlights the flow of the wind over an object
- Smoke from a localised chemical fire can be blown in the wind to form a plume of pollution