# Ordinal utility

In economics, an **ordinal utility** function is a function representing the preferences of an agent on an ordinal scale. The ordinal utility theory claims that it is only meaningful to ask which option is better than the other, but it is meaningless to ask *how much* better it is.

For example, suppose George tells us that "I prefer A to B and B to C". George's preferences can be represented by a function *u* such that:

But the only meaningful message of this function is the order ; the actual numbers are meaningless. Hence, George's preferences can also be represented by the following function *v*:

The functions *u* and *v* are ordinally equivalent – they represent George's preferences equally well.

Contrast this with cardinal utility theory: the latter claims that the differences between preferences are also important. In *u* the difference between A and B is much smaller than between B and C, while in *v* the opposite is true. Hence, *u* and *v* are *not* cardinally equivalent.

The ordinal utility concept was first introduced by Pareto in 1906.^{[1]}

## Notation

Suppose the set of all states of the world is and an agent has a preference relation on . It is common to mark the weak preference relation by , so that reads "the agent wants B at least as much as A".

The symbol is used as a shorthand to the indifference relation: , which reads "The agent is indifferent between B and A".

The symbol is used as a shorthand to the strong preference relation: , which reads "The agent strictly prefers B to A".

A function is said to *represent* the relation if:

## Related concepts

### Indifference curve mappings

Instead of defining a numeric function, an agent's preference relation can be represented graphically by indifference curves. This is especially useful when there are two kinds of goods, *x* and *y*. Then, each indifference curve shows a set of points such that, if and are on the same curve, then .

An example indifference curve is shown below:

Each indifference curve is a set of points, each representing a combination of quantities of two goods or services, all of which combinations the consumer is equally satisfied with. The further a curve is from the origin, the greater is the level of utility.

The slope of the curve (the negative of the marginal rate of substitution of X for Y) at any point shows the rate at which the individual is willing to trade off good X against good Y maintaining the same level of utility. The curve is convex to the origin as shown assuming the consumer has a diminishing marginal rate of substitution. It can be shown that consumer analysis with indifference curves (an ordinal approach) gives the same results as that based on cardinal utility theory — i.e., consumers will consume at the point where the marginal rate of substitution between any two goods equals the ratio of the prices of those goods (the equi-marginal principle).

### Revealed preference

Revealed preference theory addresses the problem of how to observe ordinal preference relations in the real world. The challenge of revealed preference theory lies in part in determining what goods bundles were foregone, on the basis of them being less liked, when individuals are observed choosing particular bundles of goods.^{[2]}
^{[3]}

## Necessary conditions for existence of ordinal utility function

Some conditions on are necessary to guarantee the existence of a representing function:

- Transitivity: if and then .
- Completeness: for all bundles : either or or both.
- Completeness also implies reflexivity: for every : .

When these conditions are met and the set is finite, it is easy to create a function which represents by just assigning an appropriate number to each element of , as exemplified in the opening paragraph. The same is true when X is countably infinite. Moreover, it is possible to inductively construct a representing utility function whose values are in the range .^{[4]}

When is infinite, these conditions are insufficient. For example, Lexicographic preferences are transitive and complete, but they cannot be represented by any utility function. ^{[4]} The additional condition required is continuity.

## Continuity

A preference relation is called *continuous* if, whenever B is preferred to A, small deviations from B or A will not reverse the ordering between them. Formally, a preference relation on a set X is called continuous if it satisfies one of the following equivalent conditions:

- For every , the set is topologically closed in with the product topology (this definition requires X to be a topological space).
- For every sequence , if for all
*i*and and , then . - For every such that , there exists a ball around A and a ball around B such that, for every in the ball around A and every in the ball around b, (this definition requires X to be a metric space).

If a preference relation is represented by a continuous utility function, then it is clearly continuous. By the theorems of Debreu (1954), the opposite is also true:

- Every continuous complete preference relation can be represented by a contiuous ordinal utility function.

Note that the Lexicographic preferences are not continuous. For example, , but in every ball around (5,1) there are points with and these points are inferior to . This is in accordance with the fact, stated above, that these preferences cannot be represented by a utility function.

## Uniqueness

For every utility function *v*, there is a unique preference relation represented by *v*. However, the opposite is not true: a preference relation may be represented by many different utility functions. the same preferences could be expressed as *any* utility function that is a monotonically-increasing transformation of *v*. E.g, if:

where is *any* monotonically-increasing function, then the functions *v* and *v* give rise to identical indifference curve mappings.

This equivalence is succinctly described in the following way:

- An ordinal utility function is
*unique up to positive monotone transformation*.

- An ordinal utility function is

In contrast, a cardinal utility function is only unique up to positive affine transformation. Every affine transformation is monotone; hence, if two functions are cardinally equivalent they are also ordinally equivalent, but not vice versa.

## Monotonicity

Suppose, from now on, that the set is the set of all non-negative real two-dimensional vectors. So an element of is a pair that represents the amounts consumed from two products, e.g, apples and bananas.

Then a preference relation is represented by a utility function .

Suppose the preference relation is *monotonically increasing*, which means that "more is always better":

Then, both partial derivatives of *v* are positive. In short:

- a monotonically-increasing preference relation can be represented by a monotonically-increasing utility function.

## Marginal Rate of Substitution

Suppose a person has a bundle and claims that he is indifferent between this bundle and the bundle . This means that he is willing to give units of x to get units of y. If this ratio is kept as , we say that is the *marginal rate of substitution (MRS)* between *x* and *y* at the point .^{[5]}^{:82}

Note that this definition of the MRS is based only on the ordinal preference relation - it does not depend on a numeric utility function. If the preference relation is represented by a utility function and the function is differentiable, then the MRS can be calculated from the derivatives of that function:

For example, if the preference relation is represented by then . The MRS is the same for the function . This is not a coincidence as these two functions represent the same preference relation - each one is a positive-monotone-transformation of the other.

In general, the MRS may be different in different points . For example, it is possible that at the MRS is high because the person has a lot of x and only one y, but at or the MRS is lower. Some special cases are described below.

## Linearity

When the MRS of a certain preference relation does not depened on the bundle, i.e, the MRS is the same for all , the indifference curves are linear and of the form:

- and the preference relation can be represented by a linear function:
- (of course, the same relation can be represented by many other non-linear functions, such as or , but it can also be represented by a linear function).
^{[5]}^{:85}

## Quasi-linearity

When the MRS depends on but not on , the preference relation can be represented by a Quasilinear utility function, of the form:

- where is a certain motonotincally-increasing function. Because the MRS is a function , a possible function can be calculated as an integral of :
^{[6]}^{[5]}^{:87} - In this case, all the indifference curves are parallel - they are horizontal transfers of each other.

## Additivity with two goods

A more general type of utility function is an additive function:

There are several ways to check whether given preferences are representable by an additive utility function.

### Double cancellation property

If the preferences are additive then a simple arithmetic calculation shows that:

- and
- implies

so this "double-cancellation" property is a necessary condition for additivity.

Debreu (1960) showed that this property is also sufficient, i.e: if a preference relation satisfies the double-cancellation property then it can be represented by an additive utility function.^{[7]}

### Corresponding tradeoffs property

If the preferences are represented by an additive function, then a simple arithmetic calculation shows that:

so this "corresponding tradeoffs" property is a necessary condition for additivity.
This condition is also sufficient.^{[8]}^{[5]}^{:91}

## Additivity with three or more goods

When there are three or more commodities, the condition for the additivity of the utility function is surprisingly *simpler* than for two commodities. This is an outcome of Theorem 3 of Debreu (1960). The condition required for additivity is **preferential-independence**.^{[5]}^{:104}

A subset A of commodities is said to be *preferentially-independent* of a subset B of commodities, if the preference relation in subset A, given constant values for subset B, is independent of these constant values. For example, suppose there are three commodities: *x* *y* and *z*. The subset {*x*,*y*} is preferentially-independent of the subset {*z*}, if for all :

- .

In this case, we can simply say that:

- for constant
*z*.

- for constant

Preferential-independence makes sense in case of independent goods. For example, the preferences between bundles of apples and bananas are probably independent of the amount of shoes and socks that an agent has, and vice versa.

By Debreu's theorem, if all subsets of commodities are preferentially-independnet of their complements, then the preference relation can be represented by an additive value function. Here we provide an intuitive explanation of this result by showing how such an additive value function can be constructed.^{[5]} The proof assumes three commodities: *x*, *y*, *z*. We show how to define three points for each of the three value functions : the 0 point, the 1 point and the 2 point. Other points can be calculated in a similar way, and then continuity can be used to conclude that the functions are well-defined in their entire range.

**0 point**: choose arbitrary and assign them as the zero of the value function, i.e:

**1 point**: choose arbitrary such that . Set it as the unit of value, i.e.:

Choose and such that the following indifference relations hold:

- .

This indifference serves to scale the units of *y* and *z* to match those of *x*. The value in these three points should be 1, so we assign:

**2 point**: Now it's time to use the preferential-independence assumption. The relation between and is independent of *z*, and similarly the relation between and is independent of *x* and the relation between and is independent of *y*. Hence:

This is good because it means that the function *v* can have the same value - 2 - in these three points. Select such that:

and assign:

**3 point**: To show that our assignments so far are consistent, we must show that all points that receive a total value of 3 are indifference points. Here, again, the preferential-independence assumption is used, since the relation between and is independent of *z* (and similarly for the other pairs), hence:

and similarly for the other pairs. Hence, the 3 point is defined consistently.

We can continue like this by induction and define the per-commodity functions in all integer points, then use continuity to define it in all real points.

An implicit assumption in point 1 of the above proof is that all three commodities are *essential* or *preference-relevant*.^{[7]}^{:7} This means that there exists a bundle such that, if the amount of a certain commodity is increased, the new bundle is strictly better.

The proof for more than 3 commodities is similar. In fact, we don't have to check that all subsets of points are preferentially-independent; it is sufficient to check a linear number of pairs of commodities. E.g, if there are different commodities, , then it is sufficient to check that for all , the two commodities are preferentially-independent of the other commodities.^{[5]}^{:115}

### Uniqueness of additive representation

An additive preference relation can be represented by many different additive utility functions. However, all these functions are similar: they are not only increasing-monotone-transformations of each other (as are all utility functions representing the same relation), they are increasing linear transformations of each other.^{[7]}^{:9} Shortly:

- An additive ordinal utility function is
*unique up to increasing linear transformation*.

- An additive ordinal utility function is

## Comparison between ordinal and cardinal utility functions

The following table compares the two types of utility functions common in economics:

Level of measurement | Represents preferences on | Unique up to | Existence proved by | Mostly used in | |
---|---|---|---|---|---|

Ordinal utility | Ordinal scale | Sure outcomes | Increasing monotone transformation | Debreu (1954) | Consumer theory |

Cardinal utility | Interval scale | Random outcomes (lotteries) | Increasing monotone linear transformation | Von Neumann-Morgenstern (1947) | Game theory |

## See also

- Preference (economics)
- Multi-attribute utility
- Consumer theory
- Marginal utility
- Lattice theory
- Convex preferences

## References

- ↑ Pareto, Vilfredo (1906). "Manuale di economia politica, con una introduzione alla scienza sociale".
*Societa Editrice Libraria*. - ↑ Chiaki Hara (6 June 1998). "Revealed Preference Theory".
*7th Toiro-kai meeting (1997/1998)*. - ↑ Botond Koszegi; Matthew Rabin (May 2007). "Mistakes in Choice-Based Welfare Analysis" (PDF).
*American Economic Review Papers and Proceedings*.**97**(2): 477–481. - 1 2 Ariel Rubinstein, Lecture Notes in Microeconomic Theory, Lecture 2 – Utility
- 1 2 3 4 5 6 7 Keeney, Ralph L.; Raiffa, Howard (1993).
*Decisions with Multiple Objectives*. ISBN 0-521-44185-4. - ↑ Peter Mark Pruzan and J. T. Ross Jackson (1963). "On the Development of Utility Spaces for Multi-Goal Systems".
*Ledelse og Erhvervsøkonomi/Handelsvidenskabeligt Tidsskrift/Erhvervsøkonomisk Tidsskrift*. - 1 2 3 Bergstrom, Ted. "Lecture Notes on Separable Preferences" (PDF). UCSB Econ. Retrieved 18 August 2015.
- ↑ Luce, R.Duncan; Tukey, John W. (1964). "Simultaneous conjoint measurement: A new type of fundamental measurement".
*Journal of Mathematical Psychology*.**1**: 1. doi:10.1016/0022-2496(64)90015-x.

## External links

- Lexicographic preference relation cannot be represented by a utility function. In Economics.SE
- Recognizing linear orders embeddable in R2 ordered lexicographically. In Math.SE.
- Murray N. Rothbard, "Towards a Reconstruction of Utility and Welfare Economics"