Farrar V-1 Flying Wing
| V-1 Flying Wing | |
|---|---|
| Role | Glider |
| National origin | United States |
| Designer | Demetrius F. Farrar Jr. |
| Introduction | 1962 |
| Status | Production completed |
| Number built | one |
|
| |
The Farrar V-1 Flying Wing is an American, single-seat, flying wing glider that was designed and constructed by Demetrius F. Farrar Jr. in 1962.[1][2]
Design and development
The V-1 was an attempt to create a glider design based on the Northrop Corporation flying wing designs of the 1940s, such as the Northrop YB-49.[1]
The aircraft is made from metal and wood, with doped aircraft fabric covering. Its 26 ft (7.9 m) span wing employs a modified Northrop airfoil and tip-mounted ailerons, in the form of rotating wing tips, of 2 ft (0.6 m) each. A single vertical stabilizer and rudder was mounted at the rear of the wing center trailing edge. The cockpit is located within the wing center section and the pilot flies in the prone position.[1]
Only one V-1 was built and it was registered with the Federal Aviation Administration in the Experimental - Amateur-built category.[1][2]
Operational history
In August 2011 the sole V-1 was still listed on the FAA aircraft register and still owned by the designer, 49 years after it was completed.[2]
Specifications (V-1)
Data from Sailplane Directory[1]
General characteristics
- Crew: one
- Wingspan: 26 ft 0 in (7.92 m)
- Wing area: 90 sq ft (8.4 m2)
- Aspect ratio: 7.51:1
- Airfoil: modified Northrop
- Empty weight: 175 lb (79 kg)
- Gross weight: 350 lb (159 kg)
Performance
- Maximum glide ratio: 36:1
- Rate of sink: 120 ft/min (0.61 m/s)
- Wing loading: 3.89 lb/sq ft (19.0 kg/m2)
See also
- Aircraft of comparable role, configuration and era
- Lamson PL-1 Quark - another prone-position glider
- Related lists
References
- 1 2 3 4 5 Activate Media (2006). "Flying Wing V-1 Farrar". Retrieved 11 August 2011.
- 1 2 3 Federal Aviation Administration (August 2011). "Make / Model Inquiry Results N66320". Retrieved 11 August 2011.