Elemental analysis

Elemental analysis is a process where a sample of some material (e.g., soil, waste or drinking water, bodily fluids, minerals, chemical compounds) is analyzed for its elemental and sometimes isotopic composition. Elemental analysis can be qualitative (determining what elements are present), and it can be quantitative (determining how much of each are present). Elemental analysis falls within the ambit of analytical chemistry, the set of instruments involved in deciphering the chemical nature of our world.

For organic chemists, elemental analysis or "EA" almost always refers to CHNX analysis—the determination of the mass fractions of carbon, hydrogen, nitrogen, and heteroatoms (X) (halogens, sulfur) of a sample. This information was very important to help determine the structure of an unknown compound, as well as to help ascertain the structure and purity of a synthesized compound. In present day organic chemistry spectroscopic technics (like NMR, both ¹H and ¹³C), mass spectrometry and chromatographic procedures have replaced EA as the primary technique for structural determination, although it still gives very useful complementary information. It is also the fastest and most inexpensive method to determine sample purity.

Antoine Lavoisier is regarded as the inventor of elemental analysis as a quantitative, experimental tool to assess the chemical composition of a compound. At the time elemental analysis was based on gravimetric determination of specific adsorbant materials before and after selective adsorption of the combustion gases.^[1][2] Today fully automated systems based on thermal conductivity or infrared spectroscopy detection of the combustion gases, or other spectroscopic methods are used.

Methods

Modern simultaneous CHNS combustion analyzer

The most common form of elemental analysis, CHN analysis, is accomplished by combustion analysis. In this technique, a sample is burned in an excess of oxygen and various traps, collecting the combustion products: carbon dioxide, water, and nitric oxide. The masses of these combustion products can be used to calculate the composition of the unknown sample. Modern elemental analyzers are also capable of simultaneous determination of sulfur along with CHN in the same measurement run.^[3][4][5][6]

Quantitative

Quantitative analysis is the determination of the mass of each element or compound present.^[7] Other quantitative methods include:

• Gravimetry, where the sample is dissolved and then the element of interest is precipitated and its mass measured or the element of interest is volatilized and the mass loss is measured.
• Optical atomic spectroscopy, such as flame atomic absorption, graphite furnace atomic absorption, and inductively coupled plasma atomic emission spectroscopy, which probe the outer electronic structure of atoms.
• Neutron activation analysis, which involves the activation of a sample matrix through the process of neutron capture. The resulting radioactive target nuclei of the sample begin to decay, emitting gamma rays of specific energies that identify the radioisotopes present in the sample. The concentration of each analyte can be determined by comparison to an irradiated standard with known concentrations of each analyte.^[8]

Qualitative

To qualitatively determine which elements exist in a sample, the methods are:

• Mass spectrometric atomic spectroscopy, such as inductively coupled plasma mass spectrometry, which probes the mass of atoms.
• Other spectroscopy which probes the inner electronic structure of atoms such as X-ray fluorescence, particle-induced X-ray emission, X-ray photoelectron spectroscopy, and Auger electron spectroscopy.
• Chemical methods
  • Sodium fusion test
  • Schöniger oxidation

Analysis of results

The analysis of results is performed by determining the ratio of elements from within the sample, and working out a chemical formula that fits with those results. This process is useful as it helps determine if a sample sent is a desired compound and confirms the purity of a compound. The accepted deviation of elemental analysis results from the calculated is 0.4%.^[9]

See also

• Dumas method of molecular weight determination

References

1. ↑ Pregl, Fritz (1917). Quantitative Micro-Analysis of Organic Substances. Berlin: Springer. ISBN 978-3-86444-914-7. 
2. ↑ "Fritz Pregl - Nobel Lecture: Quantitative Micro-Analysis of Organic Substances". www.nobelprize.org. Retrieved 2016-07-04. 
3. ↑ "Aarhus University: Elemental Analysis Facility". 3 July 2016. Retrieved 3 July 2016. 
4. ↑ sciences, Faculté des. "G.G. Hatch Stable Isotope Laboratory - Techniques - Quantitative Analysis". www.isotope.uottawa.ca. Retrieved 2016-07-04. 
5. ↑ Sahu, Ramesh Chandra; Patel, Rajkishore; Ray, Bankim Chandra (2011-08-01). "Removal of hydrogen sulfide using red mud at ambient conditions". Fuel Processing Technology. 92 (8): 1587–1592. doi:10.1016/j.fuproc.2011.04.002. 
6. ↑ Käldström, Mats; Meine, Niklas; Farès, Christophe; Rinaldi, Roberto; Schüth, Ferdi (2014-04-22). "Fractionation of 'water-soluble lignocellulose' into C5/C6 sugars and sulfur-free lignins". Green Chemistry. 16 (5). doi:10.1039/C4GC00168K. ISSN 1463-9270. 
7. ↑ From Columbia Encyclopedia on answers.com: http://www.answers.com/library/Columbia+Encyclopedia-cid-2284496: chemical analysis
8. ↑ "Neutron Activation Analysis". Analytical Chemistry Group. Retrieved 28 November 2012. 
9. ↑ University of London: http://www.ucl.ac.uk/pharmacy/facilities/research-services/chn-elemental-microanalysis