Compressor stall

A compressor stall is a local disruption of the airflow in a gas turbine or turbocharger compressor. It is related to compressor surge which is a complete disruption of the flow through the compressor. Stalls range in severity from a momentary power drop (occurring so quickly it is barely registered on engine instruments) to a complete loss of compression (surge) necessitating a reduction in the fuel flow to the engine.

Stall was a common problem on early jet engines with simple aerodynamics and manual or mechanical fuel control units, but has been virtually eliminated by better design and the use of hydromechanical and electronic control systems such as Full Authority Digital Engine Controls. Modern compressors are carefully designed and controlled to avoid or limit stall within an engine's operating range.

Types

An animation of an axial compressor showing both the stator and rotor blades.

There are two types of compressor stall:

Rotating stall

Rotating stall is a local disruption of airflow within the compressor which continues to provide compressed air but with reduced effectiveness. Rotating stall arises when a small proportion of airfoils experience airfoil stall disrupting the local airflow without destabilising the compressor. The stalled airfoils create pockets of relatively stagnant air (referred to as stall cells) which, rather than moving in the flow direction, rotate around the circumference of the compressor. The stall cells rotate with the rotor blades but at 50–70% of their speed, affecting subsequent airfoils around the rotor as each encounters the stall cell. Propagation of the instability around the flow path annulus is driven by stall cell blockage causing an incidence spike on the adjacent blade. The adjacent blade stalls as a result of the incidence spike, thus causing stall cell "rotation" around the rotor. Stable local stalls can also occur which are axi-symmetric, covering the complete circumference of the compressor disc but only a portion of its radial plane, with the remainder of the face of the compressor continuing to pass normal flow.

A rotational stall may be momentary, resulting from an external disturbance, or may be steady as the compressor finds a working equilibrium between stalled and unstalled areas. Local stalls substantially reduce the efficiency of the compressor and increase the structural loads on the airfoils encountering stall cells in the region affected. In many cases however, the compressor airfoils are critically loaded without capacity to absorb the disturbance to normal airflow such that the original stall cells affect neighbouring regions and the stalled region rapidly grows to become a complete compressor stall.

Axi-symmetric stall or compressor surge

Axi-symmetric stall, more commonly known as compressor surge; or pressure surge, is a complete breakdown in compression resulting in a reversal of flow and the violent expulsion of previously compressed air out through the engine intake, due to the compressor's inability to continue working against the already-compressed air behind it. The compressor either experiences conditions which exceed the limit of its pressure rise capabilities or is highly loaded such that it does not have the capacity to absorb a momentary disturbance, creating a rotational stall which can propagate in less than a second to include the entire compressor.

The compressor will recover to normal flow once the engine pressure ratio reduces to a level at which the compressor is capable of sustaining stable airflow. If, however, the conditions that induced the stall remain, the return of stable airflow will reproduce the conditions at the time of surge and the process will repeat.[1] Such a "locked-in" or self-reproducing stall is particularly dangerous, with very high levels of vibration causing accelerated engine wear and possible damage, even the total destruction of the engine, such as occurred with Scandinavian Airlines Flight 751.

Causes

A compressor will only pump air in a stable manner up to a certain pressure ratio. Beyond this value the flow will break down and become unstable. This occurs at what is known as the surge line on a compressor map. The complete engine is designed to keep the compressor operating a small distance below the surge pressure ratio on what is known as the operating line on a compressor map. The distance between the 2 lines is known as the surge margin on a compressor map. Various things can occur during the operation of the engine to lower the surge pressure ratio or raise the operating pressure ratio. When the 2 coincide there is no longer any surge margin and a compressor stage can stall or the complete compressor can surge as explained in preceding sections.

Factors which erode compressor surge margin

The following, if severe enough, can cause stalling or surging.

Effects

Sukhoi T-50 PAK FA suffering a compressor stall at MAKS 2011.

Compressor axially-symmetric stalls, or compressor surges, are immediately identifiable because they produce one or more extremely loud bangs from the engine. Reports of jets of flame emanating from the engine are common during this type of compressor stall. These stalls may be accompanied by an increased exhaust gas temperature, an increase in rotor speed due to the large reduction in work done by the stalled compressor and in the case of multi-engine aircraft yawing in the direction of the affected engine due to the loss of thrust. Severe stresses occur within the engine and aircraft, particularly from the intense aerodynamic buffeting within the compressor.

Response and recovery

The appropriate response to compressor stalls varies according to the engine type and situation, but usually consists of immediately and steadily decreasing thrust on the affected engine. While modern engines with advanced control units can avoid many causes of stall, jet aircraft pilots must continue to take this into account when dropping airspeed or increasing throttle.

Notable stall occurrences

Aircraft development

Rolls-Royce Avon engine

The Rolls-Royce Avon turbojet engine was affected by repeated compressor surges early in its 1940s development which proved difficult to eliminate from the design. Such was the perceived importance and urgency of the engine that Rolls-Royce licensed the compressor design of the Sapphire engine from Armstrong Siddeley to speed development.

The engine, as redesigned, went on to power aircraft such as the English Electric Canberra bomber, and the de Havilland Comet and Sud Aviation Caravelle airliners.

Olympus 593

During the 1960s development of Concorde a major incident occurred when a compressor surge caused a structural failure in the intake. The hammershock which propagated forward from the compressor was of sufficient strength to cause an inlet ramp to become detached and expelled from the front of the intake. The ramp mechanism was strengthened and control laws changed to prevent a re-occurrence.[4]

Aircraft crashes

U.S. Navy F-14 crash

A compressor stall contributed to the 1994 death of Lt. Kara Hultgreen, the first female carrier-based United States Navy fighter pilot. Her aircraft, a Grumman F-14 Tomcat, experienced a compressor stall and failure of its left engine, a Pratt and Whitney TF30 turbofan, due to disturbed airflow caused by Hultgreen's attempt to recover from an incorrect final approach position by executing a sideslip; compressor stalls from excessive yaw angle were a known deficiency of this type of engine.

Southern Airways Flight 242

The 1977 loss of Southern Airways Flight 242, a Douglas DC-9-31, while penetrating a thunderstorm cell over Georgia was attributed to compressor stalls brought on by ingestion of large quantities of water and hail which blocked bleed air removal from both of its Pratt & Whitney JT8D-9 turbofan engines. The stalls were so severe as to cause the destruction of the engines, leaving the flight crew with no choice but to make an emergency landing on a public road; 62 passengers and another 8 people on the ground were killed.

1997 Irkutsk Antonov An-124 crash

An Antonov 124 transport plane was destroyed when it crashed immediately after takeoff from Irkutsk-2 Airport in Russia. Three seconds after lifting off from Runway 14, at a height of about 5 metres (16 ft), the number 3 engine surged. Climbing away with a high angle of attack, engines 1 and 2 also surged, causing the aircraft to crash some 1,600 metres (5,200 ft) past the end of the runway. It struck several houses in a residential area, killing all 23 on board, and 45 people on the ground.[5]

Trans World Airlines Flight 159

On November 6, 1967, TWA Flight 159, a Boeing 707 on its takeoff roll from the then-named Greater Cincinnati Airport, passed Delta Air Lines Flight 379, a Douglas DC-9 stuck in the dirt a few feet off the runway's edge. The first officer on the TWA aircraft heard a loud bang, now known to have been a compressor stall induced by ingestion of exhaust from Delta 379 as it was passed. Believing a collision had occurred, the copilot aborted the takeoff. Because of its speed, the aircraft overran the runway, injuring 11 of the 29 passengers, one of whom died four days later as a result of the injuries.

Scandinavian Airlines Flight 751

In December 1991 Scandinavian Airlines Flight 751, a McDonnell Douglas MD-81 on a flight from Stockholm to Copenhagen, crashed after losing both engines due to ice ingestion leading to compressor stall shortly after takeoff. Due to a newly installed auto-throttle system designed to prevent pilots reducing power during the takeoff climb, the pilot's commands to reduce power on recognising the surge were countermanded by the system, leading to engine damage and total engine failure. The airliner successfully made a forced landing in a forest clearing without loss of life.

US Airways Flight 1549

US Airways Flight 1549, an Airbus A320, floating in the Hudson River after bird strikes caused compressor stalls and complete failure of both engines.

On January 15, 2009, US Airways Flight 1549, an Airbus A320, ditched in the Hudson River about five minutes after takeoff. The apparent cause was compressor stall in both engines after flying through a flock of birds about 90 seconds after takeoff. This same aircraft may have suffered a compressor stall on the right engine two days earlier.[6] [7] After an incident in which an Airbus A321-200 experienced compressor stalls on both engines during initial climbout on December 15, 2008, an EASA Emergency Airworthiness Directive 2008-228 requested operators of CFM56-5B engines (operated on the plane that ditched in the Hudson River) to monitor exhaust gas temperatures (EGT) for deterioration and make sure that at least one engine shows less than 80 °C deterioration in its EGTs. The FAA have issued the same requirements as Airworthiness Directive AD 2009-01-01 with immediate effect.[8]

See also

References

The Jet Engine - Rolls-Royce plc, 1995. ISBN 0-902121-23-5.

Notes

  1. Kerrebrock 1992, p.261.
  2. The crash of Air France Flight 4590 was initiated by a piece of titanium alloy, dropped from a DC-10, on the runway. The metal debris ruptured a tire of the Air France Concorde, and pieces of the exploding tire damaged the plane, rupturing a fuel tank and causing wing structural failure and engine failure. While the metal debris did not cause a compressor failure, the Concorde accident is an example of a small piece of metal debris being dropped by one aircraft onto a runway and struck by another aircraft, and it is certainly possible that such a piece of debris, once deposited on a runway, might be thrown up by a wheel forward of a jet engine's intake and ingested by the engine, causing compressor damage. Furthermore, the surges of the port engines of the Flight 4590 Concorde could be examples of compressor stall, induced by the spikes in internal engine pressure as leaking fuel was ingested into the engines (outside of throttle control) and rapidly burned.
  3. "Jet Propulsion for Aerospace Applications" 2nd edition 1964 Walter J.hesse Nicholas V.S. Mumford, Pitman Publishing Corporation p201
  4. Trubshaw, Brian; Edmondson, Sally. Brian Trubshaw Test Pilot. p 110. ISBN 0 7509 1838 1
  5. http://aviation-safety.net/database/record.php?id=19971206-0
  6. http://www.newsday.com/news/local/newyork/ny-nyplan206005334jan20,0,5076269.story "Experts: Plane that crashed had prior engine problem"
  7. http://avherald.com/h?article=413aaea4&opt=0 "Incident: US Airways A320 near Newark on Jan 13th 2009, compressor stall"
  8. http://avherald.com/h?article=4129d6a4 "European Emergency Directive calls for CFM56 engine inspections and changes"

Bibliography

  • Kerrebrock, Jack L. "Aircraft Engines and Gas Turbines", 2nd edition. Cambridge, Massachusetts: The MIT Press, 1992. ISBN 0-262-11162-4.

External links

This article is issued from Wikipedia - version of the 11/28/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.